test probe การใช้

• PIN diodes are sometimes used as input protection devices for high frequency test probes.
• Remove the fuse from the panel then touch the test probes to the fuse ends.
• He just needs Test probe's of the right impedance.
• Test probes range from very simple, robust devices to complex probes that are sophisticated, expensive, and fragile.
• A test probe is often supplied as a "'test lead "', which includes the probe, cable and terminating connector.
• To measure the effectiveness of the naps, tests probing memory, alertness, response time, and other cognitive skills were used.
• A subsurface deposit of bricks and brick fragments approximately 5 cm below the surface was revealed through test probing.
• Touch the test probes to the terminals ( be sure to maintain polarity ) and observe the meter reading.
• Detection is accomplished using a simple DC voltmeter, with test probe leads placed in various locations in the plumbing.
• A "'test probe "'is a physical device used to connect test equipment to a device under test ( DUT ).
• The JTAG test architecture provides a means to test interconnects between integrated circuits on a board without using physical test probes.
• To overcome the disappearing access for test probes, instrumentation technology began to be embedded into semiconductors and onto printed circuit boards.
• A directly connected test probe ( so called 1?probe ) puts the unwanted lead capacitance across the circuit under test.
• Measurement of low resistance requires lead resistance ( measured by touching the test probes together ) to be subtracted for best accuracy.
• Usually a very simple device, it normally provides an amplifier, and a loudspeaker, often battery-powered and packaged into a small, hand-held test probe.
• One specific form of RPI uses a multi-probe assembly that includes a test probe contained within the sheath of an outer reference probe.
• Test probes in the soil have found human bone fragments, but they were scattered in a way suggesting that the graves have been disturbed.
• Spatial and functional vicinity tests probe a patient to physically locate the various body parts in relation to others and by function; however these tests are usually failed.
• Building the line was challenging with problems at Ipswich with tunnel construction and at Stowmarket where the local marsh swallowed up a lot of material with test probes finding the bog was 80 feet deep!
• Better quality general purpose oscilloscopes include a calibration signal for setting up the compensation of test probes; this is ( often ) a 1 kHz square-wave signal of a definite peak-to-peak voltage available at a test terminal on the front panel.